Midsection network hub

A Dynon network hub will be placed at the midsection interconnects, into which the following units will be plugged

Pitch servo - 4 x 20AWG (network hub via DB9)

Roll servo - 4 x 20AWG (network hub via DB9)

The power and disconnect wires of the two servos will be consolidated into 2 x 20AWG (pos, neg) + 1 x 22AWG (disconnect) and passed through the CPC interconnect defined below

Magnetometer - 9 x 22AWG (network hub via DB9)

REVISION 250625

This midsection network hub will be omitted. All three of the above cables will be taken all the way to the panel, where the hub in the HDX1100 tray offers two unused ports, and the SV-COM-PANEL offers one unused port.

Alternatively, the servo network connections can be consolidated, so just two network cables can run to the panel, which can then plug into the panel hub.